Aspire Flexus Pro Replacement Pods
by Aspire
No reviews yet — be the firstAspire Flexus Pro replacement pods with a roomy 3ml and the mesh coil built in. 0.6ohm for a warmer draw or 1ohm for a tight MTL. Side-fill, two per pack.
0.6 Ohm · 2ml
£4.99sold individually · inc VAT
Strength: 2ml
Quantity:
1
Free delivery over £40
Same-day dispatch
TPD compliant
Trade support
Written and fact-checked by the VapeCity team · Updated June 2026
What are the Aspire Flexus Pro Replacement Pods?
Most replacement pods top out at 2ml, which for a steady vaper means a refill or two before teatime. The Aspire Flexus Pro pod holds 3ml, and that fifty percent more liquid is the whole point. For a moderate user one fill often sees out the day, which turns the Flexus Pro from a device you keep topping up into one you mostly leave alone. The replacement pods carry that quiet convenience forward.
Inside each pod is a mesh coil, built straight in, so when the coil tires you swap the whole pod rather than wrestling a separate coil into place. Two resistances cover the bases: 0.6ohm for a warmer, more vapour-forward draw, and 1ohm for a tighter MTL that leans towards a cigarette. The push-fit drops in without ceremony, the side-fill keeps refilling tidy, and they come two to a pack, one in use and one in reserve. Restocking other kit? The full Aspire replacement pods range has the rest.
- 3ml capacity, bigger than most MTL pods, so you refill less often.
- Mesh coil built into the pod, so a swap is one part, no fiddly coil to fit.
- 0.6ohm for a warmer, fuller draw, or 1ohm for a tight cigarette-style MTL.
- Clean side-fill port with a push-aside plug, no tools.
- Two per pack, so a spare is always waiting in the drawer.
On this page
Why the 3ml capacity matters day to day
Going from 2ml to 3ml is a fifty percent jump in how much liquid you carry between fills. If you get through three or four millilitres a day, a 2ml pod has you refilling twice. The 3ml usually covers the day on a single fill, and for lighter users the midday top-up disappears entirely. That is a real quality-of-life nudge, not a spec-sheet boast.
The bigger reservoir is also kinder to the coil. With more liquid in reserve the wick rarely runs close to dry, which is where dry hits and that scorched edge to the flavour creep in. Keeping any pod above the halfway mark is good practice whatever its size, but a 3ml pod is simply more forgiving than a 2ml one that drains faster and demands your attention sooner.
Which Flexus Pro pod: 0.6ohm or 1ohm?
The 0.6ohm is the warmer, livelier pod. It pushes more vapour and the draw sits somewhere between a loose MTL and a restricted lung hit, depending how hard you pull. It gets on best with 50/50 or 60/40 juices and suits 10mg salts or lower-strength 3mg to 6mg freebase. Reach for it if you want more warmth and a bigger hit of flavour.
The 1ohm is the strict MTL. Tighter, cooler, more restrained vapour, and a draw that sits closest to a cigarette. It pairs best with 20mg nic salt for a smooth, satisfying hit. If you have settled on the Flexus Pro as your daily and you want the most cigarette-like feel it can give, this is the pod.
Structurally they are the same bar the coil and the airflow that comes with it, and both make full use of the 3ml. Stuck choosing? The 0.6ohm is the more versatile across juice types, while the 1ohm is the better first pick for anyone freshly off the cigarettes.
How to fill the Aspire Flexus Pro pod
A ten-second job once you have done it once. The only rule worth obeying is letting a fresh pod soak before you vape it.
- 1Pop the pod out and find the side-fill port under the silicone plug.
- 2Push the plug aside and drip your e-liquid down the inside wall, avoiding the central airflow tube.
- 3Fill to just below the top, then press the plug firmly back in.
- 4Stand a fresh pod upright for three to five minutes so the mesh coil wicks through.
- 5Drop the pod back into the Flexus Pro until it clicks, and start with a couple of gentle puffs.
How long does a Flexus Pro pod last?
Anywhere from one to two weeks on typical use, depending on how hard you vape and what you fill it with. The first warning is a quiet dip in flavour, a slightly muted or off note that was not there when the pod was new. A burnt taste is the blunt one: that pod is done, swap it now.
Sweet and dessert juices burn through pods faster than tobacco, menthol or fruit, because all that sugar caramelises onto the wick. If your daily is a custard or a sweet bakery, check the pod weekly rather than fortnightly. The two-pack means the replacement is already in the drawer when the first one calls it a day.
Burnt taste on a new pod
It was vaped before it soaked. Fill it, wait five minutes, then prime with a couple of gentle pulls.
Burnt taste on an older pod
The coil is spent. One to two weeks is a fair run, less on sweet juice. Swap in the spare.
Leaking or gurgling
Check the fill plug is fully seated, do not overfill past the line, and avoid storing it on its side.
Weak flavour or thin vapour
Make sure the pod is fully clicked home, and try the 0.6ohm if you want more warmth than the 1ohm gives.
The good
- Roomy 3ml, so far fewer refills than a 2ml pod
- Two resistances cover both a fuller and a tighter draw
- Whole-pod swap, no separate coil to fit
- Clean side-fill and a spare in every pack
- More forgiving on the coil thanks to the bigger reserve
The catch
- Fits only the Flexus Pro, not other Aspire pods
- Coil built in, so you replace the whole pod, not just a coil
- Sweet and dessert juices shorten coil life
What’s in the kit
- 2 × Aspire Flexus Pro replacement pods (0.6ohm or 1ohm)
Specifications
| Compatible device | Aspire Flexus Pro |
|---|---|
| Resistance options | 0.6ohm, 1ohm |
| Pod capacity | 3ml |
| Fill type | Side-fill, push-aside plug |
| Coil type | Mesh, built into the pod |
| Connection | Push-fit |
| Pack quantity | 2 pods per pack |
| Price | 2 for £21.99 |
Frequently asked questions
Are the Flexus Pro pods interchangeable with Pixo pods?
No. The Flexus Pro and Pixo pods are each made for their own device, with different dimensions, connections and airflow. They are not swappable, so always order by the exact device you own. You can find the rest of the line on the Aspire replacement pods page.
Can I refill a Flexus Pro pod more than once?
Yes. The pod is built to be refilled again and again through the side-fill port until the built-in coil wears out. It is not a single-use item. Replace the pod when the flavour drops off, not after one fill.
What e-liquids work best in the 0.6ohm pod?
The 0.6ohm is versatile. It runs well with 50/50 juices and most nic salts, and 60/40 blends suit the warmer end of its output. Very high-VG liquids above 70% can wick slowly at this resistance and give dry notes, so keep below that. Salts at 10mg to 20mg are the popular daily pairing.
How many pods come in a pack?
Two. One to use and one spare, so when the first coil fades you are not left waiting on a delivery. At 2 for £21.99 that works out around eleven pounds a pod.
Delivery
| Standard UK delivery2–3 working days | £2.99 |
|---|---|
| Next-day deliveryorder before 3pm, Mon–Fri | £5.99 |
| Orders over £40free standard UK delivery | Free |
Order before 3pm and we dispatch the same working day. Everything ships in plain, discreet packaging from UK stock, and it’s all TPD-compliant.
Returns
You have a 14-day right to cancel online orders. Because e-liquids, pods, disposables and pouches are sealed for hygiene, change-of-mind returns are accepted only when the item is unused and in its original, unopened packaging — opened or used products can’t be refunded. Anything faulty, damaged or incorrectly supplied is fully covered under the Consumer Rights Act, return postage on us.
Full details on our returns & refund policy page.
Customer reviews
No reviews yet — be the first to review Aspire Flexus Pro Pod 2 Pack.
