Aspire Flexus Pro Empty Pod
by Aspire
No reviews yet — be the firstEmpty Aspire Flexus Pro pod shells, no coil fitted. Move a still-good coil into a fresh body, or keep a separate pod for each flavour. 2ml or XL.
2ml
£0.99sold individually · inc VAT
Quantity:
1
Free delivery over £40
Same-day dispatch
TPD compliant
Trade support
Written and fact-checked by the VapeCity team · Updated June 2026
What is the Aspire Flexus Pro Empty Pod?
Sometimes it is the pod that fails, not the coil. A hairline crack near the fill port, a leak that starts overnight, a pod you dropped one too many times. The Aspire Flexus Pro Empty Pod exists for exactly that moment. It is the pod body on its own, no coil inside, so you drop your still-good coil into a fresh shell and carry on rather than paying to replace a coil that had days left in it.
There are two sizes. The 2ml sits inside the UK TPD limit and suits anyone who likes to switch flavours often or keep an eye on how much they are getting through. The XL holds more for longer stretches between refills. Both take the same Flexus Pro coils, which you will need to buy separately since these shells arrive empty. You can browse the rest of the Aspire replacement pods range while you are at it.
- Bare pod shells for the Aspire Flexus Pro, with no coil fitted.
- Two sizes: 2ml (UK TPD-compliant) and XL for fewer refills.
- Swap a cracked pod body without throwing away a coil that still works.
- Run a dedicated pod per flavour, so no two juices ever mingle.
- Press-fit coil seat at the base, no tools needed.
On this page
What is an empty pod shell actually for?
The Flexus Pro splits into two parts: the pod body that holds your liquid and a coil head that presses into the base. Nine times out of ten when something goes wrong it is the coil that has tired out, not the body. Now and then it is the other way round, and that is where a bare shell earns its keep.
The classic case is a cracked pod. Plastic gives out at the stress points, usually around the fill port or the base, and suddenly liquid is weeping where it should not. If the coil inside is only a few days old and still tasting fine, replacing the whole filled pod is just throwing money away. A fresh empty shell lets you lift the good coil across and keep going.
The other big use is flavour separation. Run two or three juices and a single pod turns them into an accidental cocktail, because the old flavour clings to the wick for a fill or two. Keep one filled shell per flavour and you switch by swapping pods, clean every time. The shell is just the vessel; which coil goes in is up to you.
Plenty of people also keep a spare shell in the drawer purely as insurance. Pods break at the worst moments, and a device sitting idle while a replacement is in the post is a device you are not vaping.
2ml or XL: which Flexus Pro pod size?
The 2ml complies with the UK Tobacco Products Directive, which caps refillable tanks at 2ml. It is the capacity you will find on almost every refillable pod sold new in this country. Go for it if you value staying inside the regulations, or if you simply like the frequent top-up as a rough gauge of your daily intake.
The XL gives you a bigger reservoir and fewer interruptions, which makes sense if you vape steadily through the day and find the 2ml runs dry too fast. It also earns its place on a trip, where a bottle of juice to refill from is not always to hand.
Both take the identical Flexus Pro coil range and seat into the device exactly the same way. Capacity is the only thing separating them, so pick on how often you want to be refilling, nothing more.
How to fit a coil into an empty Flexus Pro pod
Two minutes, and the only thing that catches people out is rushing the priming. Skip the soak and the first pull tastes of burnt cotton, every time.
- 1Press your compatible Flexus Pro coil firmly into the base of the empty shell until it clicks and sits flush.
- 2Prime it: drip two or three drops of e-liquid straight onto the exposed wicking ports on the coil.
- 3Open the side fill port by pushing the silicone plug aside, then fill the pod and press the plug back in.
- 4Stand the pod upright and leave it three to five minutes so the wick soaks through properly.
- 5Drop the pod into the Flexus Pro until it seats, and take a couple of gentle priming puffs first.
New Flexus Pro pod leaking or tasting burnt?
A fresh shell that misbehaves almost always comes down to the coil fit or skipping the soak. Run through these first.
Burnt taste from the off
The coil was vaped dry. Re-prime it, fill, then wait five minutes before the first draw.
Leaking around the base
The coil is not seated. Push it firmly home until it clicks and sits flush, and do not overfill past the line.
Liquid weeping from the fill port
The silicone plug has not gone fully back in. Press it down evenly all the way round.
Old coil tastes off in the new shell
The transferred coil was further gone than it seemed. Drop in a fresh coil and the new shell will be fine.
The good
- Saves a good coil when only the pod body has failed
- Lets you keep a clean pod per flavour
- Two sizes, 2ml compliant or XL for fewer refills
- Tool-free press-fit coil and side fill
- Cheap to stock a spare in the drawer
The catch
- No coil included, so you need one separately
- Fits only the Flexus Pro, not other Aspire pods
- XL capacity is not UK TPD-compliant for retail-filled tanks
What’s in the kit
- 1 × Aspire Flexus Pro empty pod shell (2ml or XL), no coil
Specifications
| Compatible device | Aspire Flexus Pro |
|---|---|
| Size options | 2ml (TPD-compliant) and XL |
| Coil included | No, sold separately |
| Fill port | Side fill, push-aside silicone plug |
| Coil fitting | Press-fit base |
| Price | From £3.99 |
| Brand | Aspire |
Frequently asked questions
Do I need to buy a coil separately for this pod?
Yes. These are empty shells with no coil head fitted, so you need a compatible Aspire Flexus Pro coil before you can vape. If you are replacing a cracked pod, you can transfer your existing working coil into the new shell. For a fresh pod, buy the Flexus Pro coils separately.
What is the difference between the 2ml and XL Flexus Pro pods?
Only the capacity. The 2ml meets UK TPD rules and suits frequent refills or flavour-swapping; the XL holds more so you refill less often. Both take the same Flexus Pro coils and seat into the device identically.
Can I move my old coil into the new pod shell?
Yes, and that is one of the main reasons to buy a bare shell. If the coil still tastes fine and has life left, press it out of the cracked pod and into the fresh one. If the flavour is already fading, fit a new coil instead so the new shell starts clean.
Why would I want more than one empty pod?
Mostly for flavours. A separate filled shell for each juice means you switch by swapping pods, with no leftover taste carrying over. A spare also keeps the device running if a pod cracks unexpectedly.
What does delivery cost?
Standard UK delivery is £2.99 over 2 to 3 working days, next-day is £5.99 if you order before 3pm, and standard delivery is free once you spend over £40.
Delivery
| Standard UK delivery2–3 working days | £2.99 |
|---|---|
| Next-day deliveryorder before 3pm, Mon–Fri | £5.99 |
| Orders over £40free standard UK delivery | Free |
Order before 3pm and we dispatch the same working day. Everything ships in plain, discreet packaging from UK stock, and it’s all TPD-compliant.
Returns
You have a 14-day right to cancel online orders. Because e-liquids, pods, disposables and pouches are sealed for hygiene, change-of-mind returns are accepted only when the item is unused and in its original, unopened packaging — opened or used products can’t be refunded. Anything faulty, damaged or incorrectly supplied is fully covered under the Consumer Rights Act, return postage on us.
Full details on our returns & refund policy page.
Customer reviews
No reviews yet — be the first to review Aspire Flexus Pro Empty Pod.
